Fischer 44126 Nail Anchor FNA II 6 x 25 H With Hook Pack x 50
The installation-friendly Hammerset anchor with hook for multiple fixings
Order within
SKU
FIS-44126
Barcode
4006209441268
£50.39
(
£41.99
Ex VAT)
(
Ex VAT)
(
Ex VAT)
Description / Fischer 44126
- The fischer nail anchor FNA II 6 with hook is made of zinc-plated steel
- The FNA II is set in a time-saving manner in the pre-positioned installation with just a few taps of the hammer
- The installed FNA II expands automatically under load
- The cone is then pulled into the expansion clip and expands it against the hole wall
- Above all, the fischer nail anchor FNA II 6 with hook is suitable for fixing air lines and hangers in internal areas
Top Features
- Hammerset installation saves time
- No reinforcement hits due to low anchorage depth This saves time and costs during series installation.
- Expansion clip provides a firm hold
- ETA approval for multiple fixings
- With hook
Advantages
- The special active principle allows for a simple hammerset installation and, therefore, a short processing time
- The extremely short anchor depth prevents reinforcement hits, and creates the conditions for a trouble-free installation
- The optimised expansion clip ensures hold when placing in the drill hole, and prevents it falling out during overhead installations.
- The massive shaft cross-section guarantees a high load-bearing capacity, thus offering an extremely high level of safety
- A range of head shapes allows for the fixing of wide-ranging fixtures, and for the ideal adaptation to suit the intended use.
Functioning
- The FNA II with nail head is suitable for push-through installation
- The FNA II M6 is suitable for pre-positioned and push-through installation
- The FNA II OE and H are suitable for pre-positioned installation
- The installed FNA II nail anchor expands automatically under load
- The cone is pulled into the expansion clip and expands it against the drill hole wall
- Available setting tools: FNA S-SBO to slip onto the drill, FNA S-SDS for series installation with a drilling hammer
- FNA S-H for the manual installation of mounting rails.
Load Table for Downloading
https://content.fischer.de/cbfiles/fischer/lastentabelle/lt_01_fna-ii_f_%23sen_%23aip_%23v2.pdf
Features / Specification
| Technical Data | |
|---|---|
| Drill hole diameter d0 6 [mm] | |
| Anchor length l 54 [mm] | |
| Min. drill hole depth h1 35 [mm] | |
| Inner diameter of the hook/eye 10 [Ø mm] | |
| Amount 50 Unit(s) | |
| GTIN (EAN Code) 4006209441268 | |
| Applications | |
| Fire protection plates | |
| Fire protection boards | |
| Ventilation systems | |
| Wire and Nonius hangers | |
| Mounting rails | |
| Metal clamps | |
| Substructures made of wood and metal | |
| Building materials | |
| Approved for: | |
| Concrete C12/15 to C50/60, cracked, for multiple fixings of non-structural applications | |
| Also suitable for: | |
| Solid sand-lime brick | |
| Natural stone with dense structure | |
| Prestressed hollow-core concrete slabs |